Anyone out there using Intercal S/W for MetCal.
I feel for you if you are!!
Quote from: RFCAL on 12-15-2010 -- 14:27:33
I feel for you if you are!!
I prefer SureCal. But, this is what the company owns. So, this is what I have to work with.
Yes, I know lots of companies that use their software. There have been some heated discussions on this message board.
If you are looking for support for MET/CAL procedure drop me a line. We have helped several companies get their procedure up and running.. Unfortunately we cannot do it free of charge; but I assure you, we are among the best in the industry.
Also, if you are looking for up-to-date procedures for the latest equipment take a gander at our procedure list, we have the largest selection of procedures for the newest equipment. And we are the only company that is an Agilent Channel Partner offering turnkey solutions.
Best of luck..
I know that when I arrived at my present company they had a huge mess with Intercal software.It took me a whole year to get everything running and even then we had to cal in Cal Lab Solutions to straighten a lot of it out to working procedures.We have 8590 series,8560 series,8360 series,and 8753 series to name a few
Call CAL LAB SOLUTIONS at 303-921-9987 to have all your INTERCAL procedures fixed
We have purchased all the InterCal procedures. I took them with a grain of salt. They are a good start but I have not had a single procedure that did not need help. But to be honest I have not gotten a procedure from Fluke that did not need help.