hello
I am unable to get calibration report in print format so like to know which printer will support this
thanks
kumar
Follow the procedure below to generate a printout of calibration shift result. Make sure
the serial interface is configured for compatibility with your peripheral device and is
attached with an RS-232C cable. The output will be paginated for a 66-line page.
1. Press the “Setup Menus” softkey; then press the “Cal” softkey. The calibration menu
appears as shown below.
PREV
MENU
2. Press the “Cal Reports” softkey. The calibration reports menu appears as shown.
PREV
MENU
3. Select one of the following softkeys to generate the printout you prefer:
• To print the main output calibration shift results press the “Print Cal Shifts”
softkey (see Figure 6-2).
• To print the calibration check shift results, press the “Print Check Shifts” softkey.
• To print raw calibration constant data as shown in Figure, press the “Print Raw
Data” softkey.
If you have difficulty generating the printout, make sure the correct cable is attached to
the peripheral device, and the interface parameters are set to the correct values. If the
input buffer of the peripheral device fills, and the device sends the calibrator a stall
command, the calibrator will stop sending data and will start a timer. If the timeout period
expires, printing is aborted and the following message appears on the display:
PREV
MENU
To remove the message, press any key.
Is it just me or does anyone else suspect this guy was just talking to himself? :-o
Nah, he has read the manual. I tried a while back but couldn't get it to work, Fluke suggests a couple cable with their part numbers, I don't know if they are like an old parallel printer cable or what. Moved on to something else & will revisit it in the future.
I saw it too when I looked back at the post and saw that the question and answer were a couple months apart...