Print Page - Dowsil 710 Oil

Title: Dowsil 710 Oil
Post by: wijogr on 01-17-2022 -- 20:01:16

I am searching for Dowsil 710 or a suitable replacement oil to be used in a 200 degree C bath. I'm finding a 27 week lead time as the government has bought up all supplies, as far as we can tell. This is used in a bath for calibrating RTD's. Any suggestions?

Title: Re: Dowsil 710 Oil
Post by: NC-Cals on 01-19-2022 -- 14:22:18

Julabo makes several high temp oils. Also Fluke has their 200.20 silicon oil.

Title: Re: Dowsil 710 Oil
Post by: GA_PMEL_RF on 05-18-2022 -- 04:02:58

Try Clearco Products Co. Inc PM-125 Pheylmethyl Silicon Fluid. NSN 9150-00-687-8339. Operating temp open system 250 degrees C. We use in in our 6331 bath. Flash point 300-482 degree C.
We never go above 250 C.

Title: Re: Dowsil 710 Oil
Post by: GA_PMEL_RF on 10-28-2022 -- 12:47:03

Clearco PM-125 Silicone Fluid. Service range -40 to 230 deg. C Open system. Using in our 6172 Bath.

PMEL Forum

General => General Discussion => Topic started by: wijogr on 01-17-2022 -- 20:01:16