I have looked all over gidep for this one and am turning up nada. Anyone have any clue as to what tech manual this would be in? It claims that I should use the operating manual, which has nothing remotely even looking like calibration data. Any help would be greatly appreciated. Oh, btw, my 1st post here. . . . i've been lurking for awhile but had nothing to say :)
Later!!
Sorry, no help w/ gidep... but welcome to the forum!
I hate to be the bearer of bad news, but it looks to me like there probably is not a real cal procedure available. I spend a lot of manhours researching procedures, as the lab where I work has strict compliance requirements. My experience with many offshore OEM's is that they often don't provide much. The GOM-802 appears to made by Good Will Instrument Co. Ltd in Taiwan (www. goodwill. com. tw). On their website all that I found were instruction manual and programming manual. The instruction had a set of specs. If your quality system allows you, I would suggest creating a data sheet to cover all of the specs listed.
If you really want to put the time into it, on the above website, you could send them an email and ask if they can provide a cal procedure. It would probably take less time to create a data sheet.
I could be wrong, but that's my thoughts.
I actually called them, and spoke to some chineese guy. . . I ended up just using the specs given and created tolerances for them. Thanks for the research tho :)