Physical-Dimensional Technician

[SMR, Inc.]

POSITION TITLE:     Physical-Dimensional Technician
LOCATION:             Robins AFB, GA; Tinker AFB, OK; Maxwell/Gunter AFB, AL; Malmstrom AFB, MT

JOB SUMMARY:
Precision Measurement Equipment Laboratory (PMEL) is looking for one well rounded Physical-Dimensional calibration technician.  Skills in the following measurement areas are desired, although any combination will be considered: Rings, Plugs/Pins, Gage Blocks, Surface Plate, Air Flow, Air Velocity, Tensiometers, Torque, Mass, Force, Oil and Air Pressure, and Optics.     

BASIC REQUIREMENTS:
1.  Minimum four (4) years experience in Test, Maintenance, and Diagnostic Equipment (TMDE) calibration and repair, preferably in a military calibration lab.  Experience to include inspecting, troubleshooting, repairing, overhauling, aligning, calibrating, and certifying TMDE, metrology laboratory working standards, and safe work practices/procedures.       

2.  Completion of the Military DOD metrology-training program or an AA in Metrology.       

3.  Possess the knowledge required to read and analyze block, schematic, wiring, and logic diagrams.       

4.  Ability to troubleshoot and repair non-functioning TMDE.       

5.  A plus is having extensive knowledge of Air Force Metrology and Calibration Program requirements including Air Force T. O. 00-20-14 and    T. O. 33K-1-100-1.       

PHYSICAL REQUIREMENTS:
1.  Lifting/Moving Requirement - up to 50 pounds.  The following activities are also often required: climbing, stooping, kneeling, reaching, standing, sitting, walking, pushing, pulling, talking, and hearing.   

Please send resume Donald Robertson at drobertson@smrpcola. com.  Wages and benefits based on locations Wage Determination or CBA. 

[metrologygeek]

... is looking for one well rounded Physical-Dimensional calibration technician.

I've gotten well rounded over the years but now my doctor tells me I have to lose some of that mass.